Assembled in 2014. Works and cuts; we are selling it as parts only just as there have likely been electronic upgrades available since it was built.
Complete table & torch set up.
Includes:
– Hypertherm Powermax 45a with machine torch
– Gecko G540 stepper drive
– 620oz stepper motors from CandCNC
– CandCNC torch height control / plasma electronics
– magnetic breakaway torch holder
– ohmic z axis FT-01K Feather Touch Ohmic Sensor Kit
– DCP-01 Digital Current Probe
– Windows XP desktop
– Licensed copy of SheetCam
– Direct drive rack and pinion. Dual steppers for the Y axis.
– Tensor / precision plasma table/gantry Patriot SDB4x8
– Table will take 4′ x 8′ sheet of metal
$4500
Electronically operated pneumatic water table to cut down on dust and smoke. Uses (2) 55 gallon barrels and around 15 psi to fill the water table in a few minutes. The water drains back into the barrels when the power is removed.
This is sold as DIY. You will be responsible for moving & set up and we will not offer any support on using it. Contact sales@pcmofnc.com with any questions.
